Abstract
Incipient fault diagnosis is closely related to isolation condition assessment. There are a great number of methods available for condition monitoring and diagnosis of power transformer isolation systems, but only few of them can take direct measurements inside the transformer. Fibre optic sensors can be applied to incipient fault diagnosis. In special, acoustic sensors are being developed for the detection and location of partial discharges in oil-filled power transformers. Towards such objective, this work reports investigation on the applicability of fibre Fabry-Perot interferometers for acoustic detection both in air and in liquids.

Abstract
In this letter, a new configuration based on two fiber loop mirrors in series using a 3x3 coupler is demonstrated. This configuration is compact and can explore the Vernier effect. The results obtained were a sensitivity of 74.9 +/- 0.2 pm/ mu epsilon for the Vernier envelope and 6.41 +/- 0.01 pm/mu epsilon for the Vernier carrier. These results were compared to the sensitivity of the setup using only one fiber loop mirror interferometer, obtaining 14.41 +/- 0.01 pm/mu epsilon. This means a magnification factor of 5.2 for the Vernier envelope. Theoretical treatment of the system was carried out, using Jones matrix calculus, and the subsequent simulation results are also presented, having obtained good agreement with the experimental data.

Abstract
We discuss the novel concept of harmonics of the Vernier effect for optical fiber sensors as a tool to break the limits of conventional optical Vernier effect currently used. The new effect provides enhancements scalable with the harmonic order. © 2021 The Author(s).

Abstract
The refractometric analysis of ethanol-water mixtures is hampered because this type of binary solution does not present a linear behavior. In this letter, a multimode graded-index fiber (GIF) tip sensor for the measurement of ethanol in binary liquid solutions of ethanol-water is proposed. The proof is fabricated by the fusion-splicing of a 500 mu m GIF to a single-mode fiber (SMF), and it operates as a refractometric sensor in reflection. To evaluate the prove potential to detected ethanol variations, samples of ethanol-water mixtures were measured at different temperatures (20 degrees C-60 degrees C). The samples have different %(v/v) of ethanol, in a range between 0% and 100%.

Abstract
Systems for wireless energy transmission (WET) are gaining prominence nowadays. This work presents a WET system based on the photo-thermoelectric effect. With an incident laser beam at lambda = 1450 nm, a temperature gradient is generated in the radial flexible thermoelectric (TE) device, with a carbon-based light collector in its center to enhance the photoheating. The three-part prototype presents a unique approach by using a radial TE device with one simple manufacturing process - screen-printing. A TE ink with a polymeric matrix of poly(3,4-ethylenedioxythiophene) polystyrene sulfonate and doped-Poly(vinyl alcohol) with Sb-Bi-Te microparticles is developed (S similar to 33 mu VK-1 and s similar to 10.31 Sm-1), presenting mechanical and electrical stability. Regarding the device, a full electrical analysis is performed, and the influence of the light collector is investigated using thermal tests, spectrophotometry, and numerical simulations. A maximum output voltage (Vout) of similar to 16 mV and maximum power density of similar to 25 mu Wm(-2) are achieved with Plaser = 2 W. Moreover, the device's viability under extreme conditions is explored. At T similar to 180 K, a 25% increase in Vout compared to room-temperature conditions is achieved, and at low pressures (similar to 10(-6) Torr), an increase of 230% is obtained. Overall, this prototype allows the supply of energy at long distances and remote places, especially for space exploration.

Abstract
The use of graphene oxide (GO) as a saturable absorber for short pulses generation in an Erbium-doped fiber laser was studied and demonstrated. The saturable absorber consisted of a thin GO film, with a high concentration of monolayer GO flakes, spray-coated on the end face of a ferrule-connected fiber. By including the saturable absorber in the laser cavity and controlling the intra-cavity polarization, the generation of shortpulsed light was achieved under mode-locking and Q-switching operations. Under mode-locking operation, it was observed a pulse train with a fundamental repetition rate of 1.48 MHz, with a working wavelength centered at 1564.4 nm. In the Q-switch operation, a pulse train with a 12.7 kHz repetition rate and a 14.3 µs pulse duration was attained for a 230-mA pump current. Further investigation showed a linear dependence of the repetition rate with the pump power, attaining frequencies between 12.7 and 14.4 kHz. © 2023 by SCITEPRESS - Science and Technology Publications, Lda.