Abstract
The integration of micro-generation (µG) in distribution networks faces new challenges concerning the technical as well as commercial management. The µG integration in the Low and medium voltage distribution networks has many advantages for the grid operation, such as voltage profiles improvement, power losses reduction, and branches congestion levels reduction. This paper presents a method for guiding continuation power flow simulation of integrating µG on distribution feeders. A base model is designed with variable capacitor bank, µG unit such as PV and Wind generation are integrated. A control method is used to improve the voltage level of each node as well as improving power factor of the systems. The electricity consumption of a university's substation area where commercial, residential and municipal load are presented are modeled using actual data collected from each single residential hall and commercial buildings. This model allows analyzing the power flow and voltage profile along each distribution feeders on continuing fashion for a 24- hour period at hour-by-hour formulation. By dividing the feeder into load zones based on distance from each load node to distribution feeder head, the impact of integration of different µG operation in different condition has been discussed. © 2019 IEEE.

Abstract
MicroGrid (MG) is becoming an important system for a massive and reliable integration of renewable energy sources. Hence, due to its benefits, photovoltaic (PV) systems are the most suitable and widely used in MGs. However, for a reliable integration of PV panels, they must be interfaced by smart power electronics devices that allow the implementation of advanced control solutions. In addition to operating as active power generator with maximum power point tracking (MPPT), the new PV systems (PVS) should behave as ancillary services providers by participating to the grid regulation, such as frequency stabilization, voltage profile control, harmonics compensation and so forth. This paper aims at reviewing the control and operation of PVS in AC MG. Control structures, active power control, MPPT and inner loops are presented and discussed. Design, analysis and control of single-stage three phase PVS in AC MG that is able to operate at MPP or as a dispatchable source are made. The control structure is validated through dynamic simulations. © 2016 IEEE.

Abstract
Photovoltaic systems (PVS) based MicroGrid (MG) should be able to operate at the maximum power point (MPP) in order to extract the maximum available power during atmospheric conditions changes. In addition to this, the PVSs should be able also to operate below the MPP in order to participate to the MG regulation such as grid frequency stabilization, voltage profile control and grid management support. This paper discusses the state of the art of operation and control of PVS in MG. Design and control of a single stage single phase PVS connected to a low voltage AC MG are presented and analyzed. A comparison between two current control methods, Proportional integral with grid voltage feed forward (PI+FF) and proportional resonant with selective harmonics compensation (PR+HC) is also made. The control structures are validated through dynamic simulation. © 2016 IEEE.

Abstract
The large scale integration of inverter-based renewable generation in isolated power systems is posing stability concerns as a result of the displacement of the conventional synchronous machines (SM). In this sense, the integration of battery energy storage systems (BESS) connected to the grid through power converters operating as grid-forming units is mandatory in order to ensure system stability. Therefore, this paper aims to perform a dynamic stability analysis of an isolated power system regarding the installation of a BESS, where it is intended to determine the minimum required grid-forming power capacity of the associated power converter that guarantees system stability under several operational scenarios. Moreover, the expected interactions between the grid-forming inverter and the conventional SM are also addressed. © 2019 IEEE.

Abstract
The hierarchical control scheme for three phase parallel connected voltage source inverters (VSI), forming a low voltage AC MicroGrid (MG)is presented and analyzed in this paper. The proposed control scheme consists of two controllers, a local controller and a centralized controller. The local controller consists of inner control loops that are composed by a voltage and current proportional resonant controllers with selective harmonics compensation, and the power sharing controller that includes the droop control and the virtual output impedance loops in order to share properly the active and reactive power between the connected VSIs. In this system, the centralized controller is designed to restore the magnitude and the frequency deviations of the AC bus voltage produced by the power sharing controller. Simulation results for three parallel connected VSIs forming a low voltage AC MG that operates in islanded mode are provided to show the effectiveness of the proposed control scheme. Active and reactive power are properly shared as well as good harmonics compensation is achieved when both linear and non-linear loads are connected to the load bus.

Abstract
The total losses volume represents a substantial amount of energy and, consequently, a large cost that is often included in the tariffs structure. Uneven connection of single-phase loads is a major cause for three-phase unbalance and a fundamental cause for active power losses, particularly in Low Voltage (LV) networks. This paper analyzes the impact of load unbalance on LV network losses. In the first phase, several load scenarios per phase are considered to characterize how losses depend on load unbalance. The second phase examines the data collected per phase on a set of real networks, aiming at illustrating real-world cases. The third phase analyzes the effect that public lighting and microgeneration may have in the load unbalance and on the subsequent energy losses. The results of this work clearly demonstrate that it is possible to reduce three-phase unbalance (and losses) through a judicious distribution of loads and microgeneration.