Abstract

Abstract
This work describes an in-fiber Michelson interferometer inclinometer which is sensitive to curvature applied in the tapered region. The performance of this inclinometer is evaluated by calculating the variation of the fringe visibility near the 1550 nm spectral range as a function of the tilt angle. It is presented the results of four experimental measurements and calculated the average and standard deviation of those measurements. The results indicate a good response of the sensor within the angular range between 3 degrees and 6 degrees. The average of those four measurements is around -0.15/degrees and the greatest standard deviation is about 5.5%.

Abstract
In this work two erbium doped optical fiber laser configurations for magnetic field measurement are implemented and compared. The first laser is set-up in a loop configuration and requires only a single FBG (Fiber Bragg Grating), acting as mirror. A second laser employs a simpler linear cavity configuration but requires two FBGs with spectral overlap to form the laser cavity. A bulk magnetostrictive material made of Terfenol-D is attached to the laser FBGs enabling modulation of its operation wavelength by the magnetic field. Moreover, a passive interferometer was developed to demodulate the AC magnetic field information where the corresponding demodulation algorithms were software based. Both configurations are tested and compared with the results showing different sensitivities and resolutions. Better performance was accomplished with the double FBGs linear cavity configuration with a resolution of 0.05 mTRMS in the range of 8 to 16 mTRMS. For the same range the loop configuration attained a resolution of 0.48 mT(RMS).

Abstract
In this paper, we analyze numerically and experimentally a remote optical sensor system based on Raman Amplification, composed by one long period grating operating as a sensor head separated by 50 km from the optical source and the interrogation unit composed by two fiber Bragg gratings. Since the active components of the system and the sensor head are separated over such a large distance, it is necessary to consider optical amplification to strengthen the optical signal. The use of Raman amplification allows reaching the desirable gain bandwidth by changing the pump lasers parameters such as the power, number of pumps and spectral position. We present the obtained measurement results of the environmental temperature for two different setups that was analyzed a priori by the numerical model. We show that the power ratio between the two central wavelengths of the FBG has a linear relation with the change of LPG resonance with temperature.

Abstract
Optical fiber optrodes are attractive sensing devices due to their ability to perform point measurement in remote locations. Mostly, they are oriented to biochemical sensing, quite often relying on fluorescent and spectroscopic techniques, but with the refractometric approach being also considered when the objective is high measurement performance, particularly when focusing on measurand resolution. In this work, we address this subject proposing and theoretically analyzing the characteristics of a fiber optic optrode relying on plasmonic interaction. The optrode structure is a fiber optic tapered tip layout incorporating a lateral bimetallic layer (silver + gold) and operating in reflection.

Abstract
In this paper, two techniques for interrogation and multiplexing of fiber loop mirror (FLM) intensity sensors based on optical time domain reflectometer (OTDR) are proposed. These configurations enable series and parallel FLM sensor interrogation. A fiber taper characterized as a displacement sensor was used as the intensity sensor. The OTDR parameters were optimized in order to obtain the best results. The optimized parameters were 100-ns pulse width and 10-dB input signal attenuation which permitted to attain similar to 18 dB dynamic range in the operating wavelength of 1550 nm. The results show a linear behavior for both configurations with similar slope, -15.3 dB/mm, in the normalized displacement range of 0.2 to 0.7 mm. It was also achieved a displacement resolution of 0.027 and 0.093 mm, for the series and parallel configurations, respectively. Sensors multiplexing are demonstrated for both configurations and the systems do not present crosstalk. Based on the experimental results, the best configuration is the parallel one. The proposed approach is a viable alternative for multiplexing and interrogation of remote fiber sensors.