Abstract
A system with fiber laser diodes and photodetector replaces the usual bulky and expensive systems for characterization of long period fiber gratings and high correlation is achieved when measuring refractive index, temperature and curvature.

Abstract
The wavelength sensitivity and spectral resolution of Mach-Zehnder fiber interferometers based on uncoated and TiO2 coated LPFGs is presented and compared with TiO2 coated single LPFGs optical fiber sensors.

Abstract
Refractive index sensors based on localized surface plasmon resonance are presented through the fabrication of gold nano-islands on top of optical fiber tips. Repeated dewetting process led to an increase of sensitivity from 60 to 186nm/RIU.

Abstract
Food labelling is a means of communication between food business operators and consumers, representing an important factor in consumer purchasing decisions. The enforcement of the new food labelling policy is aimed to improve food safety and public health through the mandatory indication of information and nutritional values. To understand the usefulness of the information provided for consumers, a survey was carried out to assess the efficacy of the information presented in food labelling. Principal component analysis was performed to obtain a smaller number of uncorrelated factors regarding the usefulness of food labelling. Results showed consumers usually do not read food labels due to lack of time and excessive information. Additionally, food labelling was observed to be more useful for specific consumer groups, such as, athletes, consumers with health conditions or consumers concerned with a healthy lifestyle. The results of the present study highlight the need of information campaigns by public health authorities to show the importance and advantages of reading food labels as well as the development of essential information which should be quickly and clearly seen and understood by consumers.

Abstract
We present a portable and low-cost system for interrogation of long-period fiber gratings (LPFGs) costing around a 30th of the price of a typical setup using an optical spectrum analyzer and a broadband light source. The unit is capable of performing real-time monitoring or as a stand-alone data-logger. The proposed technique uses three thermally modulated fiber-coupled laser diodes, sweeping a few nanometers around their central wavelength. The light signal is then modulated by the LPFG and its intensity is acquired by a single photo-detector. Through curve-fitting algorithms the sensor transmission spectrum is reconstructed. Testing and validation were accomplished by inducing variations in the spectral features of an LPFG through changes either in external air temperature from 22 to 425 degrees C or in refractive index (RI) of the surrounding medium from 1.3000 to 1.4240. A dynamic resolution between 3.5 and 1.9 degrees C was achieved, in temperatures from 125 to 325 degrees C. In RI measurements, maximum wavelength and optical power deviations of 2.75 nm and 2.86 dB, respectively, were obtained in the range from 1530 to 1570 nm. The worse RI resolution obtained was 3.47x10(-3). The interrogation platform was then applied in the detection of iron corrosion, expressing wavelength peak values within 1.12 nm from the real value in the region between 1530 and 1570 nm.

Abstract
A femtosecond laser direct writing system was developed to explore the fabrication of long-period fiber gratings (LPFGs) in SMF28 fibers. The LPFGs, showing the mode LP1,6 at 1500 nm, were exposed to high-temperature annealing up to 950 °C. Modifications in the refractive index (RI) modulation are observed through a blue-shift in the LPFG attenuation bands and above 850 °C, the mode LP1,7 appear at 1600 nm. The wavelength sensitivity to external RI from 1.300 to 1.452 was estimated for both modes before and after annealing. Greater sensitivity was found for the higher order mode in the entire range reaching 2400 nm/RIU around 1.440.