Abstract
This paper presents a comparative study of the behaviour of different kinds of optical fibre sensors in response to high temperatures. It compares the performance of regenerated fibre Bragg gratings (FBGs) written in hydrogen-loaded and non-loaded fibres with long period gratings (LPGs) written through the two different processes of ultraviolet (UV) irradiation and electrical arc discharges. This work shows the importance of the use of hydrogen-loaded fibres to achieve regenerated FBGs capable of withstanding high temperatures as high as 955 degrees C. In addition, the results demonstrated that LPGs recorded by electric arc discharges have higher thermal resistance than LPGs written by UV radiation.

Abstract
Optical coherence tomography (OCT) imaging at 1060 nm region proved to be a successful alternative in ophthalmology not only for resolving intraretinal layers, but also for enabling sufficient penetration to monitor the sub-retinal vasculature in the choroids when compared to most commonly used OCT imaging systems at 800 nm region. To encourage further clinical research at this particular wavelength, we have developed a compact fiber optic source based on amplified spontaneous emission (ASE) centered at similar to 1060 nm with similar to 70 nm spectral bandwidth at full-width half maximum (FWHM) and output power >20 mW. Our approach is based on a combination of slightly shifted ASE emission spectra from a combination of two rare-earth doped fibers (Ytterbium and Neodymium). Spectral shaping and power optimization have been achieved using in-fiber filtering solutions. We have tested the performances of the source in an OCT system optimized for this wavelength.

Abstract
In this work the behavior of an optical fiber Long Period Grating (LPG) refractometer with the variations of the surrounding refractive index is discussed. The objective is to characterize optical fiber refractometers sensitive to surrounding refractive index, higher and lower than the cladding. For values of surrounding refractive index higher than the cladding, the LPG does not show enough sensitivity. For this reason, a nanolayer of an organic material was coated onto the fiber, using the Langmuir-Blodgett technique. We characterized LPG covered with different nanolayers thickness (110 and 120 nm) relatively to changes in surrounding refractive index.

Abstract
We study the origin of antisymmetric perturbation of the fiber in are-induced long-period gratings that couple the core mode into the antisymmetric cladding modes. We demonstrate that this perturbation is caused by a temperature gradient in the fiber, which is induced, in turn, by a temperature gradient in the arc discharge.

Abstract
In this work an all optical hot-wire flowmeter based on a silver coated fibre incorporating a long period grating and a Bragg grating is demonstrated. Optical energy at 1480 nm propagating down the fibre is coupled by the long period grating into the fibre cladding and absorbed by the metallic coating deposited on the fibre surface over the Bragg grating position. This absorption acts like a hot-wire raising locally the fibre temperature, which is effectively detected by the FBG resonance shift. The temperature raise depends on the flow speed of the surrounding air that has the effect to cool the fibre. In this way, the FBG Bragg wavelength shift can be related with the flow speed. Results obtained demonstrate the working principle and a flow speed resolution of 0.08 m/s is demonstrated.

Abstract
In this work. the LPG-assisted fibre Michelson modal interferometer is studied as a sensing structure to environmental refractive index, temperature and liquid level when coherence addressing and heterodyne interrogation are considered. The effects on measurand sensitivity of the order of the cladding mode excited by the LPG, of the degree c etching of the sensing fibre and of the fibre type used are investigated.