Abstract
Long period fibre gratings (LPFG) have found an increasing interest due to the easy fabrication in any kind of fibre through the induced electric arc technique with low cost and flexibility. They have been used in applications such as gain-flattening and band-rejection, and for sensing strain, temperature and chemical and biological parameters. The sensitivity of LPFG increases when the fibre is coated with certain thin films. In this short review it is presented the recent developments and applications of these kind of sensors.

Abstract
This work reports the theoretical investigation of optical fiber surface plasmon resonance sensors incorporating bimetallic layer combinations. Different metals like silver, gold, copper, and aluminum are considered to investigate the refractometric sensing properties of tapered and tip optrode phase-interrogated optical fiber plasmonic sensor structures. It is shown that the gold-silver combination, coupled to a tip optrode layout, is capable of maximizing the resolution and operation range of these sensing structures for environmental refractive index measurement.

Abstract
The combustion of coal wastes resulting from mining is of particular environmental concern, and the importance of proper management involving real-time assessment of their status and identification of probable evolution scenarios is recognized. Continuous monitoring of the combustion temperature and emission levels of certain gases allows for the possibility of planning corrective actions to minimize their negative impact on the surroundings. Optical fiber technology is well suited to this purpose and here we describe the main attributes and results obtained from a fiber optic sensing system projected to gather data on distributed temperature and gas emissions in these harsh environments.

Abstract
A Fabry-Perot interferometer based on an array of soda-lime glass microspheres is proposed for temperature sensing. The microspheres are introduced in a hollow-core silica tube using a tapered fiber tip. After the insertion of each microsphere the sensor is subjected to temperature measurements. The sensor exhibits non-linear behavior and a dependence on the number of microspheres is observed. A maximum sensitivity of 11.13 pm/degrees C is achieved, when there is only one microsphere inside the capillary structure.

Abstract
A metrological assessment of grating-based optical fiber sensors is proposed with the aim of providing an objective evaluation of the performance of this sensor category. Attention was focused on the most common parameters, used to describe the performance of both optical refractometers and biosensors, which encompassed sensitivity, with a distinction between volume or bulk sensitivity and surface sensitivity, resolution, response time, limit of detection, specificity (or selectivity), reusability (or regenerability) and some other parameters of generic interest, such as measurement uncertainty, accuracy, precision, stability, drift, repeatability and reproducibility. Clearly, the concepts discussed here can also be applied to any resonance-based sensor, thus providing the basis for an easier and direct performance comparison of a great number of sensors published in the literature up to now. In addition, common mistakes present in the literature made for the evaluation of sensor performance are highlighted, and lastly a uniform performance assessment is discussed and provided. Finally, some design strategies will be proposed to develop a grating-based optical fiber sensing scheme with improved performance.

Abstract
In this work an investigation of long period fiber gratings (LPFGs) over coated with iron (Fe) thin layers with different thicknesses and subjected to oxidation in air atmosphere under controlled temperature is presented. The formation of iron oxides was monitored in real time by following the optical features of the LPFG attenuation band. The morphology of the oxide layer was further analyzed by scanning electron microscope (SEM). Preliminary results show that iron coated LPFGs can be used as sensors for early warning of corrosion in projects where metal structures made of iron alloys are in contact with atmospheric air.