Abstract
Optical fiber sensors based on the phenomenon of plasmonic resonance can be interrogated applying different methods, the most common one being the spectral approach where the measurand information is derived from the reading of the wavelength resonance dip. In principle, a far better performance can be achieved considering the reading of the phase of the light at a specific wavelength located within the spectral plasmonic resonance. This approach is investigated in this work for surface plasmon based fiber optic sensors with overlays which are combinations of bimetallic layers, permitting not only to tune the wavelength of the plasmon resonance but also the sensitivity associated with the phase interrogation of the sensors. The metals considered for the present analysis are silver, gold, copper, and aluminum.

Abstract
An analytical model based on geometrical optics and multilayer transfer matrix method is applied to the surface plasmonic resonance supported by fibre taper structures in the context of optical sensing applications. Phase interrogation is considered in particular as a methodology to attain enhanced sensitivities, and the performance of the sensing heads as function of the metal clad and taper parameters is analyzed. General topics concerning the actual relevance of plasmonics are also presented, first in a global perspective and then when applied to sensing.

Abstract
In this paper real time monitoring of oxidation of transition metals using long period fiber gratings (LPFG) is performed for nickel, copper, titanium, chromium and zinc. A thin layer is deposited over the LPFG with physical process deposition and is annealed up to 700 degrees C in air with a small oven. The whole oxidation process can be monitored by tracking the LPFG features of the attenuation band which results in an abrupt change when the oxidation occurs depending on the metal sample. A preliminary study to optimize optical fiber sensors sensitivity allowing choosing the correct oxide layer in a specific application is presented.

Abstract
Many optical systems based on Surface Plasmon Resonance (SPR) have been developed for work as refractometers, chemical sensors or even for measure the thickness of metal and dielectric thin films. These kinds of systems are usually large, expensive and cannot be used for remote sensing. Optical fiber sensors based on SPR has been widely studied for the last 20 years with several configurations mostly using multimode optical fibers with large cores and plastic claddings. Sensors based on SPR present very high sensitivity to refractive index variations when compared to the traditional refractive index sensors. Here we propose a SPR sensor based in a single mode fiber. The fiber end is chemically etched by emersion in a 48% hydrofluoric acid solution, resulting a single mode fiber with the cladding removed in a small section. A resonance dip around 1580 nm was attained in good agreement with the simulation scenario that takes into account the real characteristics of the fiber.

Abstract
This work reports the theoretical investigation of optical fiber surface plasmon resonance sensors incorporating bimetallic layer combinations. Different metals like silver, gold, copper, and aluminum are considered to investigate the refractometric sensing properties of tapered and tip optrode phase-interrogated optical fiber plasmonic sensor structures. It is shown that the gold-silver combination, coupled to a tip optrode layout, is capable of maximizing the resolution and operation range of these sensing structures for environmental refractive index measurement.

Abstract
This work reports the theoretical investigation of optical fiber surface plasmon resonance sensors incorporating an internal metallic layer of silver covered with an oxide layer. This research is supported by the application of an effective analytical model combining geometrical optics with the transfer matrix theory for stratified optical media. Different oxide materials like titanium dioxide, silicon dioxide, and aluminum oxide are considered aiming to achieve increased/enhanced sensitivity to refractive index variations of the external medium, particularly when addressing phase interrogation. It is shown that the combination of a 50-nm thickness silver inner layer with a dielectric titanium oxide layer of a specific thickness enables high-performance phase sensitivity reading and is compatible with tailoring the sensor working region to the third telecommunication wavelength window around 1550 nm.